miniature aircraft Fury 55 X-CELL Assembly Instructions Manual page 25

Locate bag 3 & 4, and the hardware for bag 3 & 4. Please take the time to identify the hardware for this bag.
Apply a small amount of
medium thread lock when
threading into metal parts
128-47
Illustration 3-4a
This step will require some parts from bag 3, and all the parts from bag 4. Refer to Illustration 3-4a and 3-4b for this step. Locate the
MA128-140 aluminum tail boom, and one MA0060-1 m3x6 socket bolt. Recall that the tail belt is already installed in the completed
frame assembly from step 2. The MA128-47 Tail Rotor drive belt must be inserted through the boom with a counter clockwise ¼ twist.
We have found that the simplest way to slide the belt through the boom is to use a bit of masking tape. This allows the belt to slide
through the boom, and also allows for determining the correct direction of the ¼ twist. As the belt is slid through the boom, insert the
boom into the boom clamps in the frame. Take note that the "notch" in the boom should be facing "up", and thread the MA0060-1 m3x6
socket bolt into the inner boom clamp. This allows for proper alignment of the tail boom.
Illustration 3-4c
Locate three MA128-144 plastic rudder pushrod guides, and the MA128-155 aluminum transmission clamp. Refer to Illustration 3-4c for
this step. Locate three MA128-144 plastic rudder pushrod guides, and the MA128-155 aluminum transmission clamp. Slide the pushrod
guides onto the tail boom. On each pushrod guide there are 3 dimples, slide the pushrod guides on dimple side first. The MA128-144
plastic rudder pushrod guides should be a snug fit. Ideally they will be spaced evenly, on the boom. The MA128-155 transmission clamp
can now be slid over the end of the boom. Note the location of the alignment holes in the boom relative to the holes in the transmission
clamp.
bags 3–4
MASKIng TAPE
fRonT of TAILBooM
noTCH IS AT THE ToP
128-140
TAIL DRIvE BELT
128-155
128-144
3x
25
0060-1
noTCH
AT ToP of
TAILBooM
Illustration 3-4b