miniature aircraft Fury 55 X-CELL Assembly Instructions Manual page 35

Illustration 5i
Illustrations 5h and 5i show the control rods parallel to the main shaft. It is important that these control rods are parallel to the main shaft.
This can be adjusted using the spacers provided and discussed and shown in illustration 5c and 5d. Also shown in Illustration 5h is the
throttle linkage, it is important that the linkage for the throttle is 90 degrees from the linkage when the throttle is at 50%, or as indicated in
the manual for the engine you are using.
Illustration 5j
SMALL PIECE
of HooK AnD
LooP TAPE
Illustration 5j shows a suggestion for mounting the wires for the gyro, rudder servo, and elevator servo. Three MA0390 wire
retainers have been provided to help make your wiring job easier. Also included is some hook and loop fastening tape which can be
cut into short lengths to gather the wires together.
noTE:
ELEvAToR SERvo RoD
IS CEnTER/vERTICAL To
MAIn SHAfT WHEn PRoPER
SERvo SPACERS ARE USED
noTE:
ALL ConTRoL RoDS
ARE PARALLEL To MAIn
SHAfT WHEn PRoPER
SERvo SPACERS ARE USED.
Illustration 5h
0390
35
SMALL PIECE
of HooK AnD
LooP TAPE
PATH of WIRES