miniature aircraft Fury 55 X-CELL Assembly Instructions Manual page 34

Illustration 5g
0103
3x
Locate six MA0133 plastic ball links, three MA0337 threaded control rods, MA128-36 servo alignment tool, three MA0103 m2x5
threaded control balls, three MA0015 m2 hex nuts, the servo horns you have chosen for your cyclic servos, and the swashplate and
washout assembly you built in the first step of this bag. It is important to "center" your servos before mounting the servo horn. A
simple tool has been provided to help you center the right and left cyclic servo, and a small hole in the frame to sight the exact center
of the threaded control ball for the elevator servo. Place the MA128-36 servo alignment tool onto the socket bolt heads located
above the main gear as shown in the illustration. When the MA128-36 servo alignment tool simply snaps over the socket bolt heads,
the tip of the servo alignment tool will point to the exact location of where the center of the threaded control needs to be. To properly
center the servos, you must power on your transmitter and receiver and place the collective stick of your transmitter in the center.
Now fit the servo horn. With some brand's servo horns you have the option of trimming the horn to the exact shape needed, and
drilling the hole for the control ball at the precise location. A suggestion for trimming the shape of a servo "wheel" is shown in the
illustration. Other brand's servo horns you only have a couple options depending on how many sides the servo horn has. On the Fury
55 it is very important to mount the threaded control ball 19-20mm from the center of the servo spline. After you have determined
where to mount the control ball on the horn, do so using an MA0015 m2 hex nut on the threads of the control ball. Thread the
six MA0133 plastic ball links onto the MA0337 threaded control rods. Make all three linkages so that approximately 9.25mm
of threaded control rod is visible in length between the MA0133 plastic ball links. See page 44 for control rod lengths. Slide the
swashplate, and washout assembly onto the mainshaft, and insure that the guide pin is inside the slot of the anti-rotation guide.
0015
3x
34
SWASHPLATE AnD
WASHoUT ASSEMBLy
noTE:
SERvo WHEEL oR
ARM MUST BE 19.0MM
oR 20.0MM fRoM SPLInE
To 0103 THREADED BALL
0337
3x
SERvo WHEEL
CUT To SIzE
128-36
SERvo ALIgnMEnT TooL