miniature aircraft Fury 55 X-CELL Assembly Instructions Manual page 33

Apply a small amount of
medium thread lock when
threading into metal parts
Illustration 5e
Locate an MA0103 m2x5 threaded ball, an MA0015 m2 hex nut, four MA0038 m2.5x10 Phillips bolts, and the servo you have chosen
to control the tail rotor. Refer to Illustration 5e for this step. Mount the MA0103 m2x5 threaded ball into the servo horn 14-15mm
from the center of the horn and use an MA0015 m2 hex nut to secure the threaded ball to the servo horn. Use four MA0038 m2.5x10
Phillips bolts to mount the tail rotor servo to the frame. PEM nuts are already installed in the frame for this purpose.
noTE:
MoDEL SHoWn
fRoM UnDERSIDE
0038
4x
Illustration 5f.1
Locate MA0367 threaded control rod, two MA0133 plastic ball links, MA0103 m2x5 threaded ball, MA0012 hex nut, four MA0038
m2.5x10 Phillips bolts, and the servo you have chosen for the throttle. Refer to Illustration 5f and 5f.1 for this step. Mount the
throttle servo on the INSIDE of the frame using the four MA0038 m2.5x10 Phillips bolts. Thread the two MA0133 plastic ball links
onto the MA0367 threaded control rod. This rod should be made so that approx. 45mm of threaded control rod is visible between
the ball studs. See page 44 for control rod lengths. Illustration 5f also shows suggested mounting points for the receiver and receiver
battery. It is usually best to mount the receiver battery in the forward most position on the tray to achieve proper center of gravity for
the model. Refer to page 42 for a diagram of the suggested receiver and battery locations.
0133
1-0103 THREADED BALL
1-0015 2MM HEx nUT
RUDDER SERvo
THRoTTLE
SERvo
RECEIvER LoCATIon
0038
4x
THRoTTLE
SERvo
BATTERy
LoCATIon
1-0103 THREADED BALL
1-0015 2MM HEx nUT
THRoTTLE SERvo
Illustration 5f
0038
4x
33
0103 + 0015
CARB ARM
0133
0367
0133
THRoTTLE RoD
ASSEMBLy