miniature aircraft Fury 55 X-CELL Assembly Instructions Manual page 22

128-99
128-96
Illustration 2g.1
0060-1
Locate the MA128-99 fuel tank, MA128-96 fuel clunk, MA128-94 fuel nipple, MA128-92 rubber fuel tank plug, MA0011-4
m5x15x0.8 washer, MA0014-F m5 fine thread hex nut, and the MA115-65 fuel line. Refer to Illustrations 2g.1 and 2g.2 for this step.
Cut the MA115-65 fuel line into an 84mm length to use as a clunk line. Attach the MA128-96 fuel clunk and the MA128-94 fuel
nipple onto the 84mm clunk line you just cut. Slide the MA128-92 rubber fuel tank plug and then the MA0011-4 washer onto the
fuel nipple, followed by the MA0014 hex nut. Before fully tightening the MA0014-F m5 fine tread hex nut, carefully push the clunk
and line into the fuel tank, and push the rubber fuel tank plug into the fuel tank opening. You will notice the fuel tank "seat" onto
the groove of the rubber fuel tank plug. Now tighten the MA0014-F m5 fine tread hex nut. Tightening this nut expands the rubber
fuel tank plug to make the seal between the rubber fuel tank plug and the tank. With the remaining piece of fuel line, we have found
that a 190mm piece works from the tank vent to the muffler pressure nipple, and a 140mm piece works from the fuel nipple to the
carburetor of the engine. The fuel tank can now be inserted into the main frame assembly. You must determine the routing of the
fuel lines to suit your model and specific accessories. Locate the MA128-85 tank mounting plate, two MA128-88 rubber fuel tank
mounts, and four MA0060-1 m3x6 socket bolts. Use two MA0060-1 m3x6 socket bolts to attach the MA128-88 rubber fuel tank
mounts to the MA128-85 tank mounting plate. Use two MA0060-1 m3x6 socket bolts to attach the MA128-85 tank mounting plate
to the right main frame. Ensure that the MA128-88 rubber fuel tank mounts are seated into the dimples on the fuel tank.
115-65
190MM Long
To MUffLER
115-65
84MM Long
128-94
128-85
0011-4
128-92
128-88
2x
22
Apply a small amount of
medium thread lock when
threading into metal parts
0014
115-65
140MM Long
To EngInE
Illustration 2g.2