miniature aircraft Fury 55 X-CELL Assembly Instructions Manual page 26

0060-1
3x
128-161
127-15
0053
Illustration 3-4d
Locate the MA128-161 left tail plate with bearing, MA127-15 13t T/R pulley, MA127-16 T/R output shaft, MA128-158 aluminum
bell crank mount, two MA128-156 m3 threaded bearing studs, MA128-157 ball bearing T/R idler, MA128-164 right tail plate with
bearing, and MA128-167 vertical fin, eight MA0060-1 m3x6 socket bolts, one MA0053 m3x5 socket set screw, one MA0056 m3x5
dog-point socket set screw, and one MA0065 m3x12 socket bolt. Refer to Illustration 3-4d for this step. Install and tighten the
MA0065 m3x12 socket bolt into the transmission clamp ensuring that the alignment holes in the transmission clamp line up with the
holes in the tail boom. Using two MA0060-1 m3x6 socket bolts install the MA128-161 left tail plate with bearing, onto the left side
of the transmission clamp. Thread one MA128-156 m3 threaded bearing stud into the inside of the left tail plate. Slide the MA127-
15 13t T/R pulley onto the MA127-16 T/R output shaft. Install the MA0056 m3x5 dog-point set screw into the pulley, making sure
that the dog point of the set screw is engaged into the dimple. Thread in the MA0053 m3x5 socket set screw into the other hole on
the pulley. There is no dimple for this set screw, it simply tightens against the T/R output shaft. Remove the masking tape from the
boom, keeping track of the ¼ twist. Slide the tail rotor output shaft assembly through the left tail plate, and place the T/R drive belt
onto the pulley. Thread the other MA128-156 m3 threaded bearing stud into the inside of the right tail plate. Place the MA128-157
T/R idler onto the left bearing stud, and use two MA0060-1 m3x6 socket screws to install the right T/R plate onto the transmission
clamp. Using two MA0060-1 m3x6 socket bolts the MA128-158 aluminum bell crank mount can now be installed. Using two
MA0060-1 m3x6 socket bolts, install the MA128-167 vertical fin.
0056
127-16
128-158
noTE:
THIS EnD of TAIL SHAfT
HAS onLy onE DIMPLE foR
TAIL PULLEy
128-156
128-157
0065
128-156
128-164
26
Apply a small amount of
medium thread lock when
threading into metal parts
0060-1
3x
128-167
0060-1
2x