Getting Started - miniature aircraft Fury 55 X-CELL Assembly Instructions Manual

Locate bag 1, and the hardware for bag 1. Please take the time to identify the hardware for this bag. Please note that the use of
medium thread locking compound is always required when a part is threaded into metal.
0060-1
Illustration 1a
Locate the right main frame side MA128-10, rear canopy mount MA128-61, front canopy mount MA128-62, and two MA0060-1
m3x6 socket bolts. Please refer to Illustration 1a for step. Install the canopy mounts on the outside of the right main frame.
128-55
128-40
Illustration 1b
Locate the MA128-55 upper main shaft bearing block, MA128-40 lower main shaft bearing block, two MA128-80 boom clamps,
six MA0061 m3x8 socket bolts, and four MA0060-1 m3x6 socket bolts. Please refer to Illustration 1b for the correct placement of
components in this step. Using the MA0060-1 m3x6 socket bolts, attach the MA128-55 upper main shaft bearing block, but do not
fully tighten the bolts at this time. Using two MA0061 m3x8 socket bolts attach the MA128-40 lower bearing block as shown. the
bolts for the bearing blocks need to remain slightly loose as the bearing blocks will have to be properly aligned in a later step. Using
MA0061 m3x8 socket bolts, attach the MA128-80 boom clamp blocks. Do not fully tighten the upper MA0061 m3x8 socket head
bolts at this time, these will be tightened after the boom is installed in a later step. Go ahead and tighten the lower MA0061 m3x8
socket bolts into the MA128-80 boom clamp blocks now.

Getting started

bag 1
128-62
0060-1
0060-1
4x
128-80
2x
11
128-61
128-10
0061
2x
0061
noTE: THE TWo UPPER
BoLTS ARE noT TIgHT
AT THIS TIME
0061
4x
Apply a small amount of
medium thread lock when
threading into metal parts