4
Disassembly/Assembly > Original Exposure System > Removing the ADF Upper Unit (L150 EUR/L150 AUS) > Procedure
7) Free the Ferrite Core [1] from the Wire Saddle [2].
8) Disconnect the terminal [1] of the Grounding Wire.
• 1 Screw (black TP) [2]
9) Disconnect the 4 connectors [3] and Flat Cable [4].
• 1 Ferrite Core [5]
10) Free the disconnected Grounding Wire [1], 4 harnesses [3], and Flat Cable [4] from the
Harness Guide [A].
[5]
[1]
[2]
x5
[4]
[3]
4
Disassembly/Assembly > Original Exposure System > Removing the ADF Upper Unit (L150 EUR/L150 AUS) > Procedure
[1]
[2]
F-4-113
[A]
[1]
[3]
F-4-114
Removing the ADF Upper Unit (L150 EUR/L150 AUS)
■ Preparation
1) Remove the Left Cover (Refer to page 4-27).
2) Remove the ADF Left Cover (Refer to page 4-23).
3) Remove the ADF Left Upper Cover (L150 EUR/L150 AUS) (Refer to page 4-26).
■ Procedure
NOTE:
When removing the ADF Delivery Roller, refer to steps 1 to 9.
1) Remove the Arm Shaft [1] of the ADF Unit, and remove the ADF Harness Cover [2] while
opening and holding the ADF Unit.
• 1 Claw [3]
• 1 Hook [4]
CAUTION:
Be careful not to tip over the ADF Unit.
[4]
4-58
F-4-115
4-58