Function; Clear; Misc-R; Misc-P - Canon L100 Service Manual

FUNCTION

■ CLEAR

COPIER > FUNCTION > CLEAR
Small Item
TEL-USER Clear the user data and the registered address data.
SSSW is not cleared.
When this service mode is executed, a message "REBOOTING..." is displayed
on the Control Panel, and the host machine is automatically restarted.
SRVC-DAT SERVICE DATA is cleared.
User data is not cleared.
HIST Each log data is cleared.
ACT-HIST: Communication log is cleared.
ACT-HIST: Each print log is cleared.
PWD-CLEAR Password of the system administrator is cleared.
ALL The following data are cleared.
USER DATA
SERVICE DATA
JOB ID
Each log
CLEAR DATE
USER DATA/ SERVICE DATA are reset to the default location value.
Appropriate values for LOCAL / SIZE-LC needs to be preset before executing
of CLEAR -> ALL When this service mode is executed without setting the
appropriate values for LOCAL / SIZE-LC, factory default settings are continued to
use.
When this service mode is executed, a message "REBOOTING..." is displayed
on the Control Panel, and the host machine is automatically restarted.

■ MISC-R

COPIER > FUNCTION > MISC-R
Small Item
SCANLAMP Execute Scanning Lamp activation operation.
Light up CIS LEDs in the following sequence: red -> green -> blue -> white.
8
Service Mode > COPIER > FUNCTION > PARAM
Description
T-8-6
Description
T-8-7
8 Service Mode > COPIER > FUNCTION > PARAM

■ MISC-P

COPIER > FUNCTION > MISC-P
Small Item
SRVC-DAT To output the system data list/ system dump list as follows;
SYS-DAT To output the system data list.
Service software switches and parameters used in FAX function are mainly
outputted.
SYS-DMP To output the system dump list.
Service data such as the number of communications, the number of receiving
pages and sending pages, and the number of error are outputted.
CNTR To output the counter report.
Counter values of use trend for reading, storage, communications, and copy are
displayed.
SPEC To output the spec report.
Current device status is printed out.

■ SYSTEM

COPIER > FUNCTION > SYSTEM
Small Item
DOWNLOAD To switch to the download mode.

■ PARAM

COPIER > FUNCTION > PARAM
Small Item
EXC-NAVI To switch of installation navigation.
Setting value
0: Enable (Default)
1: Disable
Set this switch to 1 after the termination of installation navigation.
Installation navigation is not executed when this switch is 1 at next start-up.
When this service mode is executed, a message "REBOOTING..." is displayed
on the Control Panel, and the host machine is automatically restarted.
8-4
Description
T-8-8
Description
T-8-9
Description
T-8-10
8-4