Auto-Coding Function - Infopia GlucoLab Operation Manual

Setting Your Blood Glucose Test Meter
Alarm time
Alarm on/off
After pressing and releas-
After pressing and releas-
ing either ? or ? buttons
ing either ? or ? buttons
to set the alarm hour and
to turn the alarm on/off,
minute, confirm with
confirm with .
CAUTION
1. **VERY IMPORTANT: Correct test unit.
Your GLUCOLAB Auto-coding blood glucose test meter is pre-set as mmol/L as test unit. An incorrect
TM
test unit will lead to an incorrect test result display. Please consult your healthcare professional if you're
not sure which test unit to use. Stored test results are displayed correctly after re-setting the test unit. See
also conversion table on page 39.
2. Without setting the date properly, the average glucose level and the results in memory will not show
proper values. It is recommended to set the blood glucose test meter before use and when new batteries
are installed.
3. It is not possible to test your blood glucose in the setting mode.
4. To turn the meter off during setup, press
14 14
www.infopia21.com
Alarm
After programming the
number of desired alarms
(5 alarms possible), con-
.
firm with
.
for at least 5 seconds.

Auto-Coding Function

CAUTION
1. Do not bend the blood glucose test strip to prevent the Automatic code recognition
failure.
2. If the code recognition label is damaged, the code recognition may fail. Please
check the code number on the LCD window with the code number on the blood
glucose test strip vial.
1. GLUCOLAB Auto-coding has automatic
TM
code recognition function.
2. It recognizes automatically the code num-
ber. This is a very convenient function pre-
venting the inconvenience of setting the
code number on the blood glucose test
meter every time.
15 15