Auto-Coding Function - Infopia Evolution Operation Manual

Setting Your Blood Glucose Test Meter

Temperature unit Number of days
for average
Press and release either
After pressing and releas-
▲ or ▼ buttons to set ℉
ing either ▲ or ▼ buttons
or ℃. Enter
button.
to set the number of days
for average calculation (3
different possible), confirm
with .

Alarm
Alarm time
After programming the
After pressing and releas-
ing either ▲ or ▼ buttons number of desired alarms
(5 alarms possible), con-
to set the alarm hour and
firm with
minute, confirm with .
CAUTION
1. **VERY IMPORTANT: Correct test unit.
Your Evolution TM blood glucose test meter is pre-set to mg/dL as test unit. A wrong test unit will lead to
wrong test result display! Please consult your healthcare professional if you're not sure which test unit to
use. Stored test results are displayed correctly after re-setting the test unit. See also conversion table on
page 38.
2. Without setting the date properly, the average glucose level and the results in memory will not show
proper values. It is recommended to set the meter before use and when new batteries are installed.
3. Yon can't test your blood glucose while in the setting mode.
4. To turn the meter off during setup, press
14
www.infopia21.com

Alarm on/off
After pressing and releas-
ing either ▲ or ▼ buttons
to turn the alarm on/off,
confirm with .
.
for at least 3 seconds

Auto-Coding Function


CAUTION
1. Do not bend the blood glucose test strip to prevent the Automatic code recognition
failure.
2. If the code recognition label is damaged, the code recognition may fail. Please
check the code number on the LCD display window with the code number on the
blood glucose test strip vial.
1. EVOLUTION has automatic code
TM
recognition function.
2. It recognizes automatically the code
number. This is a very convenient
function preventing the inconven-
ience of setting the code number
on the blood glucose test meter
every time.
15