Auto-Coding Function - Infopia Element Lite Instructions For Use Manual

Setting Your Blood Glucose Test Meter
Number of days for average
Temperature unit
Press and release eithe or After pressing and releasing
either
buttons to set or
number of days for average
button.
calculation (3 different possible),
confirm with
Alarm time Alarm
After pressing and releasing After programming the number of
either or buttons to set the desired alarms (5 alarms possible),
alarm hour and minute, confirm confirm with
with .
CAUTION
1. **VERY IMPORTANT: Correct test unit.
®
Your Element Lite blood glucose test meter is pre-set to mg/dL as test
A wrong test unit will lead to wrong test result display! Please consult your
healthcare professional if you're not sure which test unit to use.
Stored test results are displayed correctly after re-setting the test unit. See also
conversion table on page 40.
2. Without setting the date properly, the average glucose level and the results in
memory will not show proper values. It is recommended to set the meter before
use and when new batteries are installed.
3. Yon can't test your blood glucose while in the setting mode.
4. To turn the meter off during setup, press
14
www.infopia21.com
Alarm on/off
After pressing and releasing either
or buttons to set the
or buttons to turn the alarm
on/off, confirm with
.
.
for at least 3 seconds

Auto-Coding Function

.
CAUTION
1. Do not bend the blood glucose test strip to prevent the Automatic code
unit.
recognition failure.
2. If the code recognition label is damaged, the code recognition may fail.
Please check the code number on the LCD display window with the
code number on the blood glucose test strip vial.
®
1. Element Lite has automatic code
recognition function.
2. It recognizes automatically the code
number. This is a very convenient
function preventing the inconvenience
of setting the code number on the
blood glucose test meter every time.
15