Auto-Coding Function - Infopia Element User Manual

Setting Your Blood Glucose Test Meter
Number of days for average Alarm on/off
After pressing and releasing
After pressing and releasing either
either or buttons to set the
or
number of days for average
on/off, confirm with
calculation (3 different possible),
confirm with .
Alarm time Alarm
After pressing and releasing After programming the number of
either or buttons to set the desired alarms (5 alarms possible),
alarm hour and minute, confirm confirm with
with .
CAUTION
1. **VERY IMPORTANT: Correct test unit.
Your Element Auto-coding blood glucose test meter is pre-set to mmol/L as test
TM
unit.
See also conversion table on page 39.
2. Without setting the date properly, the average glucose level and the results in
memory will not show proper values. It is recommended to set the meter before
use and when new batteries are installed.
3. Yon can't test your blood glucose while in the setting mode.
4. To turn the meter off during setup, press
14
www.infopia21.com
buttons to turn the alarm
.
.
for at least 3 seconds

Auto-Coding Function

CAUTION
1. Do not bend the blood glucose test strip to prevent the Automatic code
recognition failure.
2. If the code recognition label is damaged, the code recognition may fail.
Please check the code number on the LCD display window with the
code number on the blood glucose test strip vial.
1. Element Auto-coding has automatic
TM
code recognition function.
2. It recognizes automatically the code
number. This is a very convenient
function preventing the inconvenience
of setting the code number on the
blood glucose test meter every time.
15