Testing Procedure - Infopia GlucoLab Operation Manual

Testing Procedure

Step 1
Firmly insert the blood glucose test strip into the blood glucose test
meter port with the "infopia" facing towards you.
The blood glucose test meter automatically turns on displaying the code,
ambient temperature and the date and time.
The GLUCOLAB TM Auto-coding will automatically recognize the blood
glucose test strip code number and adjust the blood glucose test meter
accordingly.
A blinking blood glucose test strip will appear at the top of the screen
indicating the blood glucose test meter is ready for testing.
Note : Inserting the blood glucose test strip in the wrong direction will turn the
blood glucose test meter on, but you will be unable to test.
Caution
1. If the code is not displayed after for a while, pull the blood glucose test strip out
of the port, and re-start the procedure from the beginning.
2. If the code on the LCD display window and on the test vial does not match, try
another new blood glucose test strip. If the mismatch persists, please contact
your local representative for help.
3. If the blood glucose test meter does not power on, pull the blood glucose test
strip out of the port, and re-insert the blood glucose test strip.
4. Avoid testing under direct sunlight, for a more accurate test result.
5. If you apply your blood sample too early, ERROR5 message will appear on
LCD ( refer to p35).
• For a more accurate test result avoid testing under direct sunlight.
22 22
www.infopia21.com
Testing Procedure
Correct
Completely Filled
Incorrect
Poorly filled
TM
GLUCOLAB Auto-coding blood glucose test meter only requires
1.0 sample volume.
Apply your blood to the glucose test strip and do not take off your finger
until you get the beep sound.The test will automatically start.
Step 2
Place the top edge of the blood glucose test strip to the area you prepared for testing.
The blood will automatically be "drawn" into the blood glucose test strip channel.
When the chamber has enough blood, your blood glucose test meter will automatically
count down.
Caution
1. If the countdown does not start, do not add more blood to the blood glucose test
strip! Discard the blood glucose test strip an restart testing.
2. If you do not conduct the test within 3 minutes, the blood glucose test meter will auto-
matically power off to save battery life. In this case the test procedure should start
again from the beginning.
3. You may get an inaccurate result if the blood sample is not completely filled in a sin-
gle action.
Applying Blood
Correct
Incorrect
23 23