Table of Contents
Advertisement
Performing a Blood Test Using and Alternate Site
To bring fresh blood to the surface of the test site, rub the test site vigor-
ously for a few seconds until you feel it getting warm.
Lance the test site with the lancing device:
1. Hold the clear cap down against the top of your
test site. Press the release button. Do not lift up.
2. Continue to hold the lancing device and gradually
increase pressure for several seconds.
3. While holding the lancing device on your test site,
look through the clear cap; until a drop of blood
appears approximate
4. Lift the lancing device straight up; be careful not
to smear the blood on your testing site.
5. Place the edge of the blood glucose test strip to
the drop of blood.
6. The blood will automatically draw into the chan-
nel of the blood glucose test strip.
You may get an inaccurate result if the blood
sample is not completely filled in a single
action.
30
30
www.infopia21.com
size
GLUCOLAB
TM
Auto-coding Blood Glucose
Test Meter Software
You can transfer test results from the GLUCOLAB
blood glucose test meter to a computer.
You can download the software from our web site.
(www.neondiagnostics.co.uk)
You can purchase the computer communication cable separately from
a local representative.
[User]
cable
TM
Auto-coding
[PC]
31
31
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the GlucoLab and is the answer not in the manual?
Questions and answers
Just put in new batteries. Keep getting Er 6
Er 6 on the Infopia GlucoLab indicates a problem with the Auto-coding label. The recommended action is to place the battery again and set the blood glucose test meter. If the Er 6 message persists, contact your local representative.
This answer is automatically generated