Ricoh G179 Service Manual page 59

7. Attach the slide drive unit [7] to the finisher and connect it to the punch unit (
x 1). Push in the slide drive unit at
8. Make sure that the punch unit moves freely and is not blocked by the screws.
9. Put the side-to-side detection unit [8] in the machine. Make sure that the two pins are
engaged correctly at the front.
10. Make sure that the side-to-side detection unit moves smoothly on its rails. If it does not,
make sure that the rails are aligned with their grooves.
11. Attach the side-to-side detection unit and connect it at the rear ( x 2,
12. Pull the short connector [9] out of the connector [10], then connect the cable [10] of the
finisher ( x 1).
This is the 3-pin connector.
SM
CÓPIA NÃO CONTROLADA
when you attach the screw
1-25
CÓPIA NÃO CONTROLADA
Punch Unit (B702)
x 2,
.
x 1, x 1).
G179