Ricoh G179 Service Manual page 244

SP2-xxx: Drum-1
pixel count modes only as a temporary measure if the ID or TD sensor is
defective.
2209* Toner Supply Rate
Toner Rate
Sets the amount of toner supplied every second by the toner supply motor.
The length of time the motor remains on is determined by the data read by
001
the TD sensor and ID sensor.
Increasing this value reduces the toner supply clutch on time. Use a lower
value if the user tends to make lots of printouts that have a high proportion
of black.
Correction Data
Displays the toner supply correction coefficient (K). It can also be used to
adjust K, but the value is changed again when VT is measured for the next
print.
002
The toner supply rate depends on the amount of toner in the toner bottle.
This change is corrected using this coefficient. This SP can be used to
check the toner supply condition. The lower the value of K, the lower the
toner density
P Pattern Cycle
2210*
Sets the interval between ID sensor pattern prints.
Job Page Count
001* Sets the interval between ID sensor pattern printing. For users that do not
make many printouts daily, set a smaller interval to compensate for the
effects of seasonal and weather changes.
Forced Page Count
002* Sets the interval between ID sensor pattern printing.
Forces creation of the ID sensor pattern to prevent low density printouts for
customers who use the machine for long print jobs.
G179
CÓPIA NÃO CONTROLADA
[10 to 800 / 60 mg/s / 5 mg ]
[25 to 300 / 300 / 25 ]
[0 to 200 / 10 / 1 sheet]
[2 to 999 / 100 / 1 sheet]
5-28
CÓPIA NÃO CONTROLADA
SM