Re-Installation; Id Sensor - Ricoh G179 Service Manual

PCDU

Re-installation

Put toner on the edge of cleaning blade 1 and the mylar at the back side of cleaning blade
1 before re-installing this blade.
After re-assembly, make sure that the front spring of the movable cleaning blade is
re-attached to the

3.5.7 ID SENSOR

1. Left cover ( Left Cover)
2. Paper exit cover (
3. Output tray ( Output Tray)
4. Exhaust duct (
5. PCDU ( PCDU (Photoconductor and Development Unit))
6. Fusing unit ( Fusing Unit)
7. ID sensor bracket [A] (
8. ID sensor [B] ( x 1)
Do SP3-001-002 to initialize the ID sensor after replacing.
G179
CÓPIA NÃO CONTROLADA
, position. (
Paper Exit Cover)
Toner Supply Motor)
x 2, x 1)
CÓPIA NÃO CONTROLADA
Drum)
3-20 SM