Ricoh G179 Service Manual page 104

PCDU
Never touch the drum surface with bare hands.
Re-installation
1. Replace the drum and close the PCDU (
2. Put the opening cap [A in the previous procedure] back in its original place.
3. Detach the spring [A] from
You must re-attach the spring to
correctly. If you fail to re-attach the spring to
blade will not contact the drum for cleaning, but the machine will operate
without generating an error. However, printouts will gradually become dirty
due to toner collecting on the drum.
4. Re-attach the spring on the rear side of the PCDU.
5. After replacing the drum, do these SPs:
SP 3001-2: ID sensor initial setting
SP 2810-1: Grayscale Setting
G179
CÓPIA NÃO CONTROLADA
x 2).
, and re-attach it to
,
3-16
CÓPIA NÃO CONTROLADA
, .
for the cleaning blade to operate
and , the movable cleaning
SM