5.1.3 SERVICE PROGRAM MODE TABLES
Please note these general changes in this section:
Group 8 (Data Log 2) is a new group of counters.
Along with the addition of Group 8, many of the Group 7 counters have been removed.
Service Table Key
Notation
[range / default / step]
*
DFU
Japan only
SSP
SM
CÓPIA NÃO CONTROLADA
What it means
Example: [-9 to +9 / 0 / 0.1 mm step]. The setting can be
adjusted in the range ±9, value reset to +3.0 after an NVRAM
reset, and the value can be changed in 0.1 mm steps with
each key press.
Value stored in NVRAM. After a RAM reset, this default value
(factory setting) is restored.
Denotes "Design or Factory Use". Do not change this value.
The feature or item is for Japan only. Do not change this
value.
This denotes a "Special Service Program" mode.
5-3
CÓPIA NÃO CONTROLADA
Service Program Mode Operation
G179