Back Of The Rack Mounting Instructions - Extron electronics MTP 15HD A Series User Manual

Back of the rack mounting instructions

The MTP can be mounted to the rear of a rack using the
Extron MBB 100 1/8 and 1/4 Back of Rack Mounting Kit
(part number 70-367-01) (see figure 3). The kit allows the
product to be vertically mounted to the front or rear rack
supports and facing either towards the front or the rear of the
rack.
Figure 3 — Attaching the back of the rack kit
1. Remove the feet from the bottom of the MTP if they are
installed.
2. Remove the two screws from one side of the unit.
Retain the screws for possible later reassembly without the
bracket.
3. Attach one bracket to the side of the unit using the longer
screws included in the kit.
4. Repeat steps 2 and 3 on the other side of the unit.
MTP 15HD A Series • Installation and Operation
S
I E
R
S E
T P
M
8