Extron electronics MTP 15HD A Series User Manual page 14

1. Remove the feet from the bottom of the MTP, if they are
installed.
2. Attach the mounting brackets to the MTP with the
provided machine screws.
3. For furniture mounting, hold the MTP with the attached
brackets against the mounting surface. Mark the bracket
screw hole locations on the mounting surface.
4. For furniture mounting, drill 3/32 inch (2 mm) diameter
pilot holes, 1/4 inch (6.3 mm) deep in the mounting surface
at the marked screw locations.
5. For furniture mounting, insert number 8 wood screws into
the four pilot holes. Tighten each screw into the mounting
surface until just less than 1/4 inch (6 mm) of the screw head
protrudes.
6. For furniture mounting, align the mounting screws with the
slots in the brackets and place the MTP against the surface,
with the screws through the bracket slots.
7. For furniture mounting, slide the MTP slightly forward or
back, then tighten all four screws to secure the MTP in place.
8. For projector mounting, secure the MTP to a projector mount
by inserting the mounting bolt through the slotted hole on
the bracket and tightening the bolt.
PMK 100
Projector
Mounting
Bracket
Projector
Figure 5 — Desk and projector mounting the MTPs
MTP 15HD A Series • Installation and Operation
Mounting
Bolt
MBU 123
Under-Desk
Mounting
Bracket
M
T P
S E
R
I E
S
10