Installing countertop dispensers with legs accessory
§ Do not tilt any unit further than 30° off vertical plane.
§ Countertop dispensers that sit on legs (not bolted to counter) can be inadvertently moved. Care should be
taken when operating and cleaning to avoid accidents.
1. Carefully tip dispenser back to expose
underside and block up in place.
2. Screw legs (shipped taped to drain pan
of dispenser) into dispenser bottom,
taking care to seat legs securely against
underside of dispenser.
3. Attach bottom panel and hardware to
bottom of dispenser with supplied screws
(Fig. 5).
4. Position unit in desired location and
adjust bullets on legs to level in both
directions.
5. Make final connections.
25CR/HR/FB and 50CR/HR/FB
CAUTION!
Fig. 5 – Bottom panel and leg assembly
leg
bottom panel
screw
9