Installing Ride Ice Machines - Follett Symphony Plus 25 series Operation And Service Manual

Installing RIDE ice machines

See Installation Instructions shipped with product for critical installation instructions for RIDE ice machines.
Failure to comply with these instructions will result in poor performance and void warranty.
1. Install RIDE ice machine following instructions shipped with product.
2. If dispenser is equipped with SensorSAFE remove protective plastic coating from dispenser lenses.
3. Remove top front cover by removing two screws at bottom corners of cover. Lift cover slightly and pull
forward. Turn on power and bin signal rocker switches. Replace front cover and secure with screws.
Test operation.
4. Clean and sanitize ice machine following instructions in ice machine manual. Discard ice made
during sanitizing process.
5. Sanitize dispenser hopper following instructions in Cleaning/descaling and sanitizing section.
Installation is complete.
Fig. 14 – Ice transport tube and ice level control stat mounting for freestanding dispensers and
countertop units with RIDE ice machine
ice level control stat
25CR/HR/FB and 50CR/HR/FB
CAUTION!
ice hose mounting bracket
0.187" (5 mm) ice tube hole
engaging pin
1"
(25.4 cm)
ice tube
13