Installing Countertop Dispensers With Legs Accessory; Installing Wall Mount Dispensers - Follett 12CI425A-LI Operation And Service Manual

Installing countertop dispensers with legs accessory (P/N AF10LBLEGS)
§ Do not tilt any unit further than 30° off vertical plane.
§ Countertop dispensers that sit on legs (not bolted to counter) can be inadvertently moved. Care should be
taken when operating and cleaning to avoid accidents.
1. Carefully tip dispenser back to expose
underside and block up in place.
2. Screw legs (shipped taped to drain pan
of dispenser) into dispenser bottom,
taking care to seat legs securely against
underside of dispenser.
3. Attach bottom panel and hardware to
bottom of dispenser with supplied screws
(Fig. 3).
4. Position unit in desired location and
adjust legs to level in both directions.
5. Make final connections.

Installing wall mount dispensers

§ WALL PREPARATION: Wall and fasteners must be of sufficient strength to carry weight of unit (185 lb
(83.9 kg). Hardware for this is not included.
Notes:
§ SensorSAFE infrared dispensing is standard.
1. Recommended minimum counter depth and mounting height shown on Fig. 6 ensures that ice will drop
into sink.
2. See Fig. 6 for model dimensions. The dimensions include the 0.5" (13 mm) mounting bracket supplied with
the unit.
3. Cut utility hole in wall as shown (Fig. 5).
4. Mount support bracket to wall using fasteners of sufficient strength (fasteners not included, see Fig. 4).
5. Rough in water and drain lines (3/4" copper recommended for drain) (Fig. 9).
6. Lift dispenser onto support bracket, positioning unit so that hook on back of dispenser is captured by
support bracket angle (Fig. 6).
7. Install two (2) supplied 3/8"-16UNC screws through bottom of support bracket into bottom of dispenser
(Fig. 4). Slotted holes in support bracket allow you to adjust and level the dispenser. Ensure that the top of
dispenser is level or tilted slightly back toward the wall.
8. Remove bottom cover and make final connections (Fig. 7).
9. Attach bottom panel and hardware to bottom of dispenser (Fig. 8).
10. Sanitize dispenser prior to use.
6
CAUTION!
Fig. 3 - Bottom panel and leg assembly
leg
CAUTION!
bottom panel
screw
12CI425A • 12HI425A