Wiring Diagram - Sensorsafe Only - Follett Symphony Plus 25 series Operation And Service Manual

Wiring diagram - SensorSafe only

SensorSafe models
SensorSAFE models provide "touchless" ice and water dispensing. When a container is placed within the
actuation zone below the ice or water chute on SensorSAFE dispenser models, an infrared signal reflects off
the container and is detected by the sensor. The sensor then sends a signal to the control board to activate the
appropriate components to dispense ice or water. LEDs on the board indicate when the board is receiving a
signal from the sensors.
A safety, shut-off feature automatically shuts off dispensing after one minute of continuous activation.
Dispensing can be restarted by moving the container away and then returning it to the actuation zone.
Dispensing can be temporarily suspended for cleaning by depressing and releasing the clean switch, located
under the left side of the top front cover. Depressing and releasing the button a second time will return the
dispenser to normal operating state. If the clean switch is not depressed a second time, the dispenser will
automatically resume normal dispense operation (CLN LED goes out) after two minutes. An LED on the control
board will light to indicate that the dispensing has been suspended by activation of the clean switch.
SensorSAFE
DISPENSERS CON-
TROL BOX
49 BLACK
9
48 WHITE
8
47 ORANGE
7
46 PURPLE
6
45 BLUE
5
44 RED
4
43 BLACK
3
42 WHITE
2
41 GREEN
1
49 BLACK
9
48 WHITE
8
47 ORANGE
7
46 PURPLE
6
45 BLUE
5
44 RED
4
43 BLACK
3
42 WHITE
2
41 GREEN
1
25CR/HR/FB and 50CR/HR/FB
99 BLACK
102 WHITE
GROUND
SCREW
1 2 3 4
98 BLACK
BIN T-STAT
100 BLACK
99 BLACK
GROUND
SCREW
POWER
1 2 3 4
103 GREEN
L1
GND
CLN
SOL WM
WTR
49 BLACK
POWER
LEVER DISPENSERS CONTROL BOX
1 2
ICE
TO
SPLASH
PANEL
WTR
98 BLACK
BIN T-STAT
100 BLACK
48 WHITE
1 2
19