Installing Wall Mount Dispensers - Follett Symphony Plus 25 series Operation And Service Manual

Installing wall mount dispensers

§ WALL PREPARATION: Wall and fasteners must be of sufficient strength to carry weight of unit (185 lb
(83.9 kg)). Hardware for this is not included.
Notes:
§ No drain pan is provided since the dispenser is
intended to be installed above a sink. (Contact
Follett if a drain pan is desired.)
§ SensorSAFE infrared dispensing is standard.
1. Recommended minimum counter depth and
mounting height shown on Fig. 6 ensures that
ice will drop into sink.
2. See Figs. 8-11 for model dimensions. The
dimensions include the 0.5" (13 mm) mounting
bracket supplied with the unit.
3. Cut utility hole in wall.
4. Mount support bracket to wall using fasteners
of sufficient strength (fasteners not included,
see Fig. 12).
5. Rough in water and drain lines (3/4" copper
recommended) (Figs. 8-11).
6. Lift dispenser onto support bracket, positioning
unit so that hook on back of dispenser is
captured by support bracket angle (Fig. 12).
7. Install two (2) supplied 3/8"-16NC screws
through bottom of support bracket into bottom
of dispenser (Fig. 12). Slotted holes in support
bracket allow you to adjust and level the
dispenser. Ensure that the top of dispenser is
level or tilted slightly back toward the wall.
8. Remove bottom cover and make final
connections.
9. Attach bottom panel and hardware to bottom of
dispenser (Fig. 13).
10
CAUTION!
Fig. 6 – Wall mount side view
24.30"
(61.7 cm)
17.03"
(43.2 cm)
18.93"
(48.1 cm)
30.00" (76.2 cm)
MIN DISTANCE TO SINK FRONT
Fig. 7– Wall mount side view
water and
drain tubing
2.00"
(5.2 cm) max.
25HR425
26.50" (67.3 cm)
50HR425
30.50" (77.5 cm)
18.00" (45.7 cm)
SUGGESTED POWER
CORD ROUTING
wall
25CR/HR/FB and 50CR/HR/FB