Installation; Before You Begin; Installing Countertop Dispensers With Rear Exiting Utilities (No Legs) - Follett Symphony Plus 25 Series Installation, Operation And Service Manual

Installation

Before you begin

§ All dispensers must be installed level in both directions to ensure proper operation.
§ Provide proper ventilation clearances.
§ Countertop units provide the option of taking utilities out bottom or back of dispenser (on countertop units with
legs, utilities exit from back).
§ Wall mount model utilities exit through back of dispenser only.
§ Directions for each installation follow.
§ DO NOT LIFT UNIT AT THESE POINTS. Panels will not support weight of unit
§ Failure to follow warning may result in equipment damage or personal injury
Installing countertop dispensers with rear
exiting utilities (no legs)
1. Position dispenser in desired location.
2. Mark dispenser outline on counter and
remove dispenser.
3. Drill four 7/16" holes in counter to anchor
dispenser to counter (Fig. 1).
4. Apply a thick bead approximately 1/4" (7 mm)
diameter of NSF listed silicone sealant (Dow
Corning RTV-732 or equivalent) 1/4" (7 mm)
®
inside marked outline of dispenser.
5. Reposition dispenser on counter and secure
to counter with four 3/8"-16NC bolts.
6. Smooth excess sealant around outside of
dispenser.
7. Make utility connections (Fig. 2).
8. Turn on water supply and check for leaks.
9. Clean dispenser and ice machine before
putting into service.
10. Turn power on and allow ice machine to
produce ice.
6 C/E25CI425A, C/E50CI425A
WARNING!
Fig. 1 Countertop anchoring locations
1.56"
(40 mm)
12.50"
(31.8 cm)
.50"
(13 mm)
Fig. 2 Utility connections as viewed from top for
countertop back access
condenser inlet
3/8" FNPT
potable water
3/8" FNPT
4X
Ø.375"
(10 mm)
hole
20" (50.8 cm)
condenser outlet
3/8" FNPT
drain
3/4" MPT
power