Installing Icemakers With Satellite-Fi Ll ™ Ice Through A Tube Technology - Follett C/E25CT400A/W-S Installation, Operation And Service Manual

Installing Satellite-fi ll icemakers
(models C/E25CR400A/W, C/E50CR400A/W, C/E25HR400A/W, C/E50HR400A/W)
See Icemaker Installation Manual (form #00124453) for critical installation instructions for
!
remote icemakers. Failure to comply with these instructions will result in poor performance and
void warranty.
1. Install Satellite-fi ll icemaker following instructions in icemaker manual.
2. Run uninsulated ice transport tube from dispenser through ice transport tube knock-out (Fig. 5G) or through
counter opening to icemaker.
3. Heat end of transport tube in cup of 160 F (71 C) hot water to soften and spread with
pliers before making connection to ease assembly and prevent coupler edge from
cutting inner wall of tube.
4. Insulate ice transport tube by sliding insulation over tube.
5. Adjust insulation to cover all exposed ice transport tubing including tubing inside
dispenser cabinet.
6. Check that insulated ice transport tube runs continuously uphill (with no dips) from
icemaker to dispenser.
7. Run bin signal wire from dispenser through utility knockout (Fig. 5F) or counter cutout to icemaker and
connect bin signal wire (two-conductor twist lock) to bin signal plug on icemaker.
8. Install appropriate plug on power cord and insert into wall socket.
9. Turn on dispenser water supply and check for leaks. Replace splash panel.
10. If dispenser is equipped with SensorSAFE remove protective plastic coating from dispenser lenses.
11. Remove top front cover by removing two screws at bottom corners of cover. Lift cover slightly and pull
forward. Turn on power and bin signal rocker switches. Replace front cover and secure with screws. Test
operation.
12. Clean and sanitize icemaker following instructions in icemaker manual. Discard sanitized ice.
12. Clean and sanitize dispenser hopper following instructions on page 16. Installation is complete.
Fig. 9 – Ice transport tube and ice level control stat mounting for freestanding dispensers and countertop
units with Satellite-fi ll icemaker
capillary tube
ice hose mounting bracket
5mm (.187) ice tube hole
13
engaging pin
26mm
ice tube
(1")
Hot Water
160 F (71 C)
3