Installing Ride Ice Machines; Installing Top Mount Ice Machines - Follett 110 Installation & Service Manual

Installing RIDE ice machines

Models C/E110CR400A/W
See Ice machine Installation Manual (form #00124453) for critical installation instructions for RIDE
ice machines. Failure to comply with these instructions will result in poor performance and void
!
warranty.
1. Install RIDE ice machine following instructions in ice machine manual.
2. Run uninsulated ice transport tube from dispenser through ice transport tube knock-out, (Fig. 5G) or through counter
opening to ice machine.
3. Insulate ice transport tube by sliding insulation over tube.
4. Adjust insulation to cover all exposed ice transport tubing including tubing inside dispenser cabinet.
5. Check that insulated ice transport tube runs continuously uphill (with no dips) from ice machine to dispenser.
6. Run bin signal wire from dispenser through utility knockout, (Fig. 5F) or counter cutout to the ice machine and connect
bin signal wire (two-conductor twist lock) to bin signal plug on ice machine.
7. Plug dispenser power cord into 20A rated NEMA 5-20 wall socket.
8. Turn on dispenser water supply and check for leaks. Replace splash panel.
9. Remove top front cover by removing two screws at bottom corners of cover. Lift cover slightly and pull forward. Turn on
power and bin signal rocker switches. Replace front cover and secure with screws. Test operation.
10. Clean and sanitize ice machine following instructions in ice machine manual. Discard sanitized ice.
11. Clean and sanitize dispenser hopper following instructions on page 13. Installation is complete.
Fig. 6 – Ice transport tube and ice level control stat mounting for freestanding dispensers and countertop units
with RIDE ice machine

Installing top mount ice machines

Models C/E110CT400A/W
Dispensers with top mount ice machines cannot be mounted on legs. They must be bolted to
!
counter. Use gloves when lifting ice machine to protect hands from sheet metal edges.
10
ice level control stat
ice hose mounting bracket
5mm (3/16") ice tube hole
engaging pin
26mm
ice tube
(1")
110 Series 220 V 60 Hz/230 V 50 Hz Ice and Water Dispensers