Installing Remote Ice Machine (Automatic Load Units Only) - Follett EVU155NW Installation, Operation And Service Manual

Installing remote ice machine
Correct installation of remote ice machine(s) is critical to proper performance of ice machine
!
and dispenser.
Check to make sure bin signal on ice machine control board is switched to 24 V connection.
Refer to installation manual packed with ice machine for important details on ice transport
tube run, ventilation requirements and other installation requirements. Failure to comply with
instructions will void warranty.
1. Position ice machine in desired location.
2. Push one end of ice transport tube(s) through hole(s) provided in side of dispenser.
3. Route tube into ice tube bracket inside dispenser and engage bracket tabs in holes located in end of ice
transport tube(s). (See drawings below.)
4. Proceed with ice transport tube installation from dispenser to ice machine in compliance with instructions
contained in ice machine installation manual packed with ice machine.
Ice tube retainer bracket
thermostat
(automatic load units only) ––––––––––––––––––––––––––––––
ice tube
Front view
25mm
ice tube
Side view
Tabs in ice tube
retainer bracket
engage holes in ice
tube and hold tube
in place
EU155N Ice and Water Dispensers
thermostat
8