Table of Contents
Advertisement
7.
CREATING MARKS
Definitions:
MARK
Can be a stand alone position or be linked to a Route. A Mark is place on the Chart page using
[MARK] or by entering in information in the MARK/WAYPONTS List NEW MARK selection.
WAYPOINTS
Always linked to a Route. Are placed on the Chart page using [ROUTE].
The difference between a Mark and a Waypoint is
a. When a Route is created using WAYPOINTS and the ROUTE is deleted the WAYPOINTs are
also deleted.
b. If a Route is created using MARKS and the ROUTE is deleted the MARKs remain.
7.0
CREATING A NEW MARK USING THE CHART PAGE
1. Move the ShuttlePoint knob to the desired or approx. Lat/Lon and press [MARK].
2. You will notice a Mark is placed under the location of the Cursor and a popup window
is shown with the exact Lat/Lon of the Mark.
3. If the position is incorrect on the CPF180i press [ENT], select EDIT using the
ShuttlePoint knob and press [ENT]. On the CPF300i, press [E
change the position, Mark name and icon type.
1
Mark placed under Cursor
Lat/Lon of Mark, DST/BRG
2
from vessel location
ONLY for CPF180i
Press [ENT] to delete, to move,
3
to edit a Mark or to show the
Marks/Waypoint List (Directory)
ONLY for CPF300i
Press Soft Key to show
4
Marks/Waypoint List
to move or to delete Mark
5
Vessel location
After entering in all the Marks it is a good practice to back up the points to an User C-CARD. Refer
to Section 11.
7.1
EDITING A MARK
If a Mark has previously been created and you wish to Edit it, move Cursor over the top of
the Mark.
CPF180i and CPF300i
NOTE
5
1
the
, to edit,
4
Figure 7.0 - Mark creation
NOTE
] that will allow you to
DIT
Page 63
R
2
3
Advertisement
Table of Contents
