Table of Contents
Advertisement
TESTING THE DOOR / WINDOW
DETECTOR
9.
Remove battery cover to activate the tamper
switch.
As the button is released the LED indicator will
illuminate for approximately 1 second to show
that the tamper switch has been triggered and a
signal is being transmitted.
10. Open the door/window to remove the Magnet
from the Detector.
As the Magnet is moved away from the Detector
the LED indicator will illuminate for
approximately 1 second to show that the
Detector has been triggered and a signal is
being transmitted.
Note: It does not matter if the LED indicator
illuminates as the magnet is brought towards
the detector.
IMPORTANT: With the battery cover fitted
the LED indicator will not flash when the
door / window is opened, (unless the battery
is low).
11. In order to communicate with the Siren, the ID
code of the Detector needs to be learned by the
Siren. By pressing the tamper switch either
located adjacent to the PCB or the rear cover of
the Detector will emit the ID code subject to the
Siren being placed in Learn Mode. Refer to
Adding a new PIR / Magnetic Door / Window
Detector to the Siren opposite.
12. Refit the battery cover.
13. Switch the Siren into Operating Mode (see
page 19).
18
ADDING A NEW PIR OR
MAGNETIC (MAG) DOOR /
WINDOW CONTACT
DETECTOR TO THE SIREN
IMPORTANT: In order to communicate with the
Siren, the ID code of the Detector needs to be
learned by the Siren. Whenever the Siren is being
set-up it will automatically enter Service Mode
when it is powered-up, ready to learn a new
Detector. Alternatively if the Siren is already in
Operating Mode, see page 19 to place the Siren
into Service Mode before adding a new Detector.
1.
Place the Siren into Learn Mode using a
linked Remote Control or Remote Keypad:
a) Remote Control
Press and hold the
5 seconds or
b) Remote Keypad
Enter the Keypad Access Code then
press-and-hold the ARM button for
5 seconds
?
?
Keypad User Access Code
When the Siren enters Learn Mode it emits a
single short beep and the both the indicator LEDs
and Learn LED will flash together slowly (once
every 2 seconds). The siren will remain in Learn
Mode for 30 seconds.
2.
a) Press the Tamper Switch on the PIR / MAG once.
If a valid signal is not received from a device
in that period it will automatically exit Learn
Mode. It will remain in Service Mode.
If the detector is new and not already linked
to the alarm zone the siren will produce two
short low volume beeps and the Indicator /
Learn LEDs will start flashing together
rapidly, (once every second).
Note: If the detector is already linked to
the siren or if there are already the maximum
12 detectors already linked to the siren then
the siren will produce a single long low
volume beep and exit Learn Mode. The
Learn / I n d i c a t o r LEDs will stop flashing.
button for
,
?
?
(hold 5
seconds)
Hide quick links:
Advertisement
Table of Contents
