Cp300/Cp300I Connections - Standard Horizon CP180 Owner's Manual

Port2 Input and Output is used by the optional FF525 (or FF520). In the diagram above you will
notice Port2 Input and Output wires are shown in gray and not used.
2.4.2.2 AIS Setup
The CP180 or CP180i has to be set up to be able to receive NMEA information from the AIS
receiver. The GPS Chart Plotter reads the AIS NMEA message VMD, type 1, 2, 3 and 5 for
AIS Class A and type 18, 19, 24 for AIS Class B. Select the used port and transmission speed
by following the procedure:
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight ADVANCED SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight IN/OUT CONNECTIONS and press [ENT] or
move the ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight PORT1 INPUT and press [ENT] or move the
ShuttlePoint knob to the right.
5. Move the ShuttlePoint knob up/down to select AIS 38400 and press [ENT] or move the
ShuttlePoint knob to the right.
If an AIS receiver is not connected, Port1 Input can be connected to most DSC VHF's for position
polling.
2.4.3

CP300/CP300i Connections

2.4.3.0 DC Power Connection
Page 20
NOTE
NOTE
GPS Chart Plotters