Demo Mode (For Dealer Use) - Standard Horizon CP180 Owner's Manual

the Video Input connector, the Soft Keys will be shown in light color in order to identify that
they are not active.
III. Quick Activation by Soft Keys
It is possible to assign the Video Input mode to any of the Soft Keys. Press one of the Soft
Keys, the Soft Keys functions are shown. Pressing and holding for 1 second one of the Soft
Keys, the Soft Keys customization list will be shown. By selecting VIDEO option it will be
possible to assign the Soft Key to execute the Video Input function. Once the Soft Key has
been assigned to Video Input, its label will show the message [V
the Soft Keys will be assigned this way: [F
on, the functioning is identical to case II.
When the PIP video window is shown, the ShuttlePoint knob can be used to move the position of
the PIP window or move the cursor around the chart page. By default the PIP window is controlled
by the ShuttlePoint knob. To change so the chart cursor can be moved, press any Soft Key, then
press [V P ]. To change back to control the PIP window press any Soft Key, then press [V
ID AGE
again.
When the PIP window is shown, the cursor and the vessels position may be shown under the PIP
window.
2.13

DEMO MODE (FOR DEALER USE)

In Demonstration Mode the GPS Chart Plotter automatically places a Destination point on
the Chart page and simulates navigation to the point. Also, the active page displayed on the
screen changes every 10 seconds. The pages are shown in the following order: Start-up
screen, GPS Status page, Chart/Compass tape page, Chart/Fish Finder page, Fish Finder
Full page, Radar page, Navigation page, Highway Page, Celestial page, NMEA Display
page.
This mode is used by dealers to promote the features of the GPS Chart Plotter when on a retail shelf.
The Demo mode can be selected from the Simulation Menu following the procedure:
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight ADVANCED SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight SIMULATION and press [ENT] or move the
ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight DEMO MODE and press [ENT] or move the
ShuttlePoint knob to the right to show the popup window.
5. Move the ShuttlePoint knob to select On and press [ENT] or move the ShuttlePoint knob
to the right.
6. Demo mode is now activated.
Once the Demo Mode is enabled, it is possible to temporally exit Demo Mode by pressing
a key and return to the GPS Chart Plotter normal operation. If a key in not touched for 30
seconds the Demo Mode will re-start.
To disable the Demo Mode follow the procedure above selecting OFF at point 5.
Page 26
S ], [P P V
ULL CREEN I IEW
NOTE
NOTE
NOTE
]. If [V ] is pressed,
IDEO IDEO
], [A S ]. From now
UTO WITCH
P
ID AGE
GPS Chart Plotters
]