Adjusting Projected Images
f
Check that the focus matches the corners (
screen.
If any areas are out of focus, use the focus lever to adjust until the
corners are the same focus.
g
) of the projected
Adjusting the Volume
You can adjust the volume using one of the following methods.
• Press the [Volume] buttons on the remote control to adjust the volume.
[
] Decreases the volume.
a
[
] Increases the volume.
b
• Adjust the volume from the Configuration menu.
Settings - Volume
s
Do not start when the volume is set too high.
A sudden increase in volume may cause loss of hearing. Always lower the
volume before powering off, so that you can power on and then gradually
increase the volume.
http://www.pureglare.com.au
To remove the Test Pattern, press the [Esc] button on the remote
control or the control panel.
Remote control
p.131
Caution
59