Others Menu - Epson EB-595Wi User Manual

List of Functions

Others Menu

Sub-menu
Set to On to monitor the projector using SNMP.
SNMP
To monitor the projector, you need to install the SNMP manager
program on your computer. SNMP should be managed by a
network administrator.
The default value is Off.
You can register up to two IP addresses for the SNMP trap
Trap IP Address
1/Trap IP Ad‐ notification destination. You can enter a number from 0 to 255 in
dress 2 each field of the address. However, the following IP addresses
cannot be used. 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x
is a number from 0 to 255)
You can set the priority gateway to a Wired LAN or Wireless
Priority Gateway
LAN.
AMX Device Dis‐ When the projector is connected to a network, set this to On to
covery allow the projector to be detected by AMX Device Discovery
Set this to Off if you are not connected to an environment
controlled by a controller from AMX or AMX Device
Discovery.
Function
g
.
http://www.pureglare.com.au
Sub-menu
Set this to On only when monitoring or controlling the projector
Crestron Room‐
View over the network using Crestron RoomView
this to Off.
s "About Crestron RoomView
When this is set to On, the following functions are not available.
• Web Control
• Message Broadcasting (EasyMP Monitor Plug-in)
Bonjour Set this to On when connecting to the network using Bonjour.
See Apple's Web site for more information on the Bonjour
service.
http://www.apple.com/
Message Broad‐ You can switch the EPSON Message Broadcasting function to
enable or disable.
casting
143
Function
®
. Otherwise, set
®
" p.120