Sam4s ER-420M Operation And Program Manual page 176

Programming the Macro Name
Up to ten function locations may be designated as Macro keys. You may wish to program a name for a
macro. For example if a macro executes a series of commands to produce daily reports, you can program
the descriptor "DAILY", so the macro can easily be identified. Macro names can also be helpful when
looking at keyboard layout information with the PC communication utility.
166 • Program Mode Programming
1. Turn the control lock to the P position.
2. To begin the program, enter 7 1 1, press the SBTL key.
7 1 1
3. Refer to the chart below and enter the number that represents the line you wish
to program; press the X/TIME key.
X X/TIME
4. If you are programming
Type up to 18
descriptor keys
or,
Enter up to 18
three-character
codes
5. Press the CASH key to finalise the program.
SBTL
SBTL
SBTL
ER-420M