Table of Contents
Advertisement
Under
WEP Wireless
6
'a' to 'f' or any numbers. It should be ten characters for 64-bit and 26 characters
for 128-bit WEP key length. Please don't enter the default key that came with
your Hub
Make a note of your new key and click
7
Any devices already connected wirelessly to your Hub will be disconnected.
8
To reconnect these, you'll need to reset their wireless connection using the
new key you've just chosen
> For more information on your Hub Manager, see page 39
> If you need some help, please go to www.bt.com/broadband/help/hub
or call 0800 111 4567 (please make sure you're at your computer, and
that it's turned on, when you call)
> For more information on wireless security, please go to
www.bt.com/broadband/help and type 'wireless security' in
the search box at the bottom of the page
My computer is showing a message 'Windows cannot configure
Q
this wireless connection' when I try to set up a wireless
connection. What can I do?
Your computer's pre-installed wireless software is preventing you from using the
Windows standard wireless software. Find your computer's wireless software by
hovering your mouse over the icons in your system tray (usually on the lower
right-hand corner of the screen). If there's a wireless icon, right-click on it to run
the wireless manager or utility. Or go to
the list.
Once you find this software, you can use it to set up your wireless connection (your
software's 'help' function may be useful, if you aren't sure how to do this) or there
may be a tick box that allows Windows to control the wireless set-up. Then follow
the instructions on page 26.
Help
32
Key, type in a new 'key' of your choice. You can use letters
Apply
Start
then
All Programs
and look through
Advertisement
Table of Contents
