Reversibility Of The Door - Electrolux EDR1000NEW Service Manual

14 REVERSIBILITY OF THE DOOR

Proceed as follows:
1. Remove the screws which secure the hinges to the cabinet
(fig.A.1). Remove the door.
2. Remove the screws which secure the hinge hole masking
plates (fig.A-2) and fit the plates to the holes to which the
hinges were previously fitted (fig.A-1).
3. Remove the canister.
4. Remove the work top.
5. Remove the left- and right-hand panels.
6. Remove the front panel hole cap (fig.A-4). To do so, squeeze
together the anchor tabs which secure it to the cabinet.
7. Remove the screws which secure the door interlock (fig.A-3) to
the cabinet and remove the lock.
8. Detach the connector from the door lock.
9. Remove the tapes from the wiring (fig. B) and separate the
wires for the door lock from the remaining wires.
10. Re-tape the remaining wiring.
11. Insert the general wiring harness into the support(s)
positioned on the duct (fig. C) and position them parallel to
the front panel so that they cannot come into contact with the
drum. Attach to the anchor using a wire tie.
12. Insert the door lock connector between the drum and the
canister container, then remove it from the position shown by
the arrow (fig.D-1).
13. Insert it beneath the front brush cover (fig.D-2), secure to the
anchors on the duct (fig.D-3), and remove the wiring from the
other side of the cabinet.
14. Insert the door lock connector and secure with screws to the
front panel (fig.E-5). Ensure that the wiring is not trapped
between the door lock and the front panel.
15. Check that the wiring is routed through all the anchors
released when removing the door lock wiring.
16. The excess section of the door lock wiring should be secured
using a wire tie to the wiring cover (fig.D-6).
17. Fit the masking cap into the hole from which the door lock
was removed (fig.E-4).
SOI/DT 2003-12 dmm 48/50
fig. B
fig. A
fig. C
fig. D
fig. E
599 36 20-08