Electrolux EDR1000NEW Service Manual page 49

18. Remove the hinges by removing the hinge screws (fig.F-
6).
19. Remove the hinge hole masking caps (fig.F-7).
20. Remove the masking cap from door latch hole (fig.F-8).
21. Remove the door latch (fig.F-9).
22. Press the hinge hole masking caps into position (fig.G-7).
23. Insert the latch hole masking cap (fig.G-8).
24. Fit the door latch (fig.G-9).
25. Screw the hinges into position (fig.G-6)
26. Position the door on the opposite side of the appliance and
screw the hinges into position (fig.H-10).
27. Replace the left - and right-hand side panels
(replacing the screws in their original positions,
otherwise the continuity of the earth circuit will be
broken).
28. Replace the work top.
29. On completion of this procedure, the appliance will
be as shown opposite (fig. I).
30. Re-position the "Push-Push" adhesive label.
SOI/DT 2003-12 dmm
fig. H
fig. I
49/50
fig. F
fig. G
599 36 20-08