Control Panel Support Assembly; Control Panel; Electronic Board; Programme Selector Rear Section - Electrolux EDR1000NEW Service Manual

13.2.2 Control panel support assembly

a. In models with the canister in the upper section: remove the canister
and remove the screws which secure the control panel to the canister
support.
b. Remove the screws which secure the control panel support to the
cabinet.
c. Lift and tilt the control panel support assembly, and remove from the
cabinet.

13.2.3 Control panel

d. Remove the screws which secure the control panel support and the
control panel to the cabinet.
e. Remove the canister (models with canister in upper section) and remove
the screws which secure the control panel to the canister container.
f. (Open the door). Slightly raise the control panel support in order to
release the control panel from the cabinet and rotate forwards.
g. Detach the upper anchors and the central (internal) anchor which secure
the control panel to the control panel support.
h. Release the lower central anchor which secures the control panel and
remove the control panel.
N.B. When replacing, reposition the light diffusers on the control panel, slightly
raise the canister support, and guide the pushbuttons carefully into the control
panel.

13.2.4 Electronic board

i. Press the anchor clip on the connector cover, lift and remove from the
board casing.
j. Detach the wiring connectors from the electronic board.
k. Remove the control panel (see 13.2.3)
l. Remove the light diffuser for the LEDs (if featured) from the board casing.
m. Check that the selector is on "0" (OFF). Remove the spindle from the
selector (including the knob rear section). To facilitate removal, use pliers
or lever off using a screwdriver.
n. Remove the screws which secure the pushbutton support to the board
and remove the support/pushbutton assembly.
o. Press the anchor tab.
p. Release the board assembly from the support by moving rightwards, and
remove.
m

13.2.5 Programme selector rear section

q. Lift the anchor tab which secures the rear section and remove the rear section.

13.2.6 Pushbuttons

r. To remove the buttons from the support, widen the anchor tabs.
SOI/DT 2003-12 dmm
n
39/50
b-d
d-e
g
i
p
p p
q
o
599 36 20-08