Reversibility Of The Door - Electrolux TC2 Service Manual

13 REVERSIBILITY OF THE DOOR

Proceed as follows:
1. Remove the screws which secure the hinges to the
cabinet (fig.A.1). Remove the door.
2. Remove the screws which secure the hinge hole masking
plates (fig.A-2) and fit the plates to the holes to which the
hinges were previously fitted (fig.A-1).
3. Remove the canister.
4. Remove the work top.
5. Remove the left- and right-hand panels.
6. Remove the front panel hole cap (fig.A-4). To do so,
squeeze together the anchor tabs which secure it to the
cabinet.
7. Remove the screws which secure the door interlock
(fig.A-3) to the cabinet and remove the lock.
8. Detach the connector from the door lock.
9. Remove the tapes from the wiring (fig. B) and separate
the wires for the door lock from the remaining wires.
10. Re-tape the remaining wiring.
11. Insert the general wiring harness into the support(s)
positioned on the duct (fig. C) and position them parallel
to the front panel so that they cannot come into contact
with the drum. Attach to the anchor using a wire tie.
12. Insert the door lock connector between the drum and
the canister container, then remove it from the position
shown by the arrow (fig.D-1).
13. Insert it beneath the front brush cover (fig.D-2), secure
to the anchors on the duct (fig.D-3), and remove the
wiring from the other side of the cabinet.
14. Insert the door lock connector and secure with screws to
the front panel (fig.E-5). Ensure that the wiring is not
trapped between the door lock and the front panel.
15. Check that the wiring is routed through all the anchors
released when removing the door lock wiring.
16. The excess section of the door lock wiring should be
secured using a wire tie to the wiring cover (fig.D-6).
17. Fit the masking cap into the hole from which the door
lock was removed (fig.E-4).
SOI/ADL 54/57
fig. B
599 38 46-21
fig. A
fig. C
fig. D
fig. E