Float; Pump (Models With Canister In Upper Section) - Electrolux EDR1000NEW Service Manual

13.4.2 Float

g
g. The float is located inside the sump.
h. To remove the float, turn it 90° clockwise as shown in the figure.
i. Lift the float and rotate outwards, and remove the float.
To replace the float, repeat this procedure in reverse sequence.

13.4.3 Pump (models with canister in upper section)

The pump, which ducts the water from the sump to the canister (in the
upper section) is located next to the sump containing the float.
j. To remove the pump from its seat, it is necessary to disconnect the
wiring connectors, remove the screw and release the anchor tab
(shown by the arrow) which secures the pump to the sump.
Remove the pump.
k. When re-assembling the pump, the float and the canister
microswitch, repeat the procedure described above in reverse
sequence. When replacing the microswitch support, insert a
screwdriver into the gap (shown by the arrow) in order to lift the
microswitch lever and place it against the top of the float. If this
procedure is not performed, the microswitch lever will remain
alongside the float and become bent. In this case, the two
components will not function correctly.
SOI/DT 2003-12 dmm
h
42/50
i
j
k
599 36 20-08