Dimensions / Reversibility Of The Door - Electrolux EDR 2000 Service Manual

1. Dimensions / Reversibility of the door

Changing door stop
- Open loading door.
- Unscrew hinge A from the front of the machine and take off the
loading door.
- Use a thin screwdriver to pry off cover plates B and C.
- Use an appropriate tool and exert pressure to unfasten locking
block D from the snap-on fixture, take out and reinsert on the
other side having rotated the block through 180°.
- Unscrew hinge A from the loading door, rotate through 180°,
reinsert on the opposite side and screw down.
- Reinsert cover plates B and C on the opposite site having first
rotated them through 180°.
- Unscrew cover plates E from the front ofthe machine, rotate
through 180°, screw on the opposite side.
- Unscrew door lock F, push down slightly and remove from the
front of the machine.
- Disconnect cable connector from door lock F.
- Press snap-in button G in and down, press cover down slightly
and remove from front ofthe machine.
- Disconnect cable connector from cover G.
- Change door lock F over to the opposite side, insert the cable
connector and screw down the door interlock.
- 0n the other side, insert the cable connector in cover G insert
cover
- Insert loading door and hinges into recesses on the front ofthe
machine and screw down.
- Once the door stop has been replaced, check the function of the
DOOR button.
Note regarding contact protection:
- The machine is only secure for operations again once all plastic
parts have been inserted.
06.2005 R.Kurzke
Height
Width
Depth
Depth (Door open)
Height can be adjusted by
Weight when empty
Loading volume (depends on programme)
permissible ambient temperature
- 3 -
85 cm
60 cm
60 cm
109 cm
1,5 cm
approx. 60 kg
max. 6 kg
+ 5°C bis + 35°C
599 522 797 EN