Table of Contents
Advertisement
Mercedes-Benz E-Class BR 211 / CLS BR 219
Preliminary Work
- Slide the passenger seat backwards as far as possible.
- Remove the vehicle keys from the ignition.
- Disconnect the battery. (in the trunk)
- Remove the side cover of the fuse box on the driver's side of the dash board.
- Remove the footwell panel under the dashboard on the passenger side.
- Remove the A-pillar panel in the passenger side.
- Remove the floor cover in the passenger footwell area.
- Loosen the footrest plate located behind this.
- Remove the cover from middle console around the gear shift stick (optional).
- Remove the A-pillar panel in the passenger side.
- Loosen the cable conduit cover next to the fond armrest.
- Open the hood.
- Let off pressure in the cooling system.
- Copy the factory number from the original type label to the duplicate type label.
- Remove years that do not apply from the duplicate label.
- Attach the duplicate label (type label) in the appropriate place.
- Open the fuel tank cap, ventilate the tank.
- Close the fuel tank cap again.
- Remove the right front and rear wheels
- Remove the front part of the right wheel house panel.
- Loosen the front section of the wheel house panel and lift it to the back.
- Remove the lower right section of the engine enclosure under the rocker panel (2 sections).
- (CLS only) loosen the front grill
- Loosen the bumper on the right side of the vehicle.
- Remove right headlight (CLS: 2 screws on the top, 1 screw from the wheel house).
- Remove the engine design cover (pull off).
- Remove the covers in the left and right engine area (turn locks 90°).
- Remove the combination filter housing (1 plastic nut, left and right snaps).
- Remove the windshield wipers.
- Pull off the gasket that runs across the water reservoir cover.
- Remove the water reservoir cover, remove the drain hose.
- Remove the windshield wiper arm and motor.
1
Heater Unit Installation Location
1 Heater unit
1
Installation
location
5
Hide quick links:
Advertisement
Table of Contents
