Preliminary Work; Heater Installation Location - Webasto Thermo Top E Installation Manual

Preliminary Work

WARNING!
- Open the fuel tank cap, ventilate the tank.
- Close the fuel tank cap again.
- Disconnect the battery "earth" or "ground" connection.
- Depressurise the cooling system.
- Copy the factory number from the original type label to the duplicate type label.
- Remove years that do not apply from the duplicate label.
- Attach the duplicate label (type label) in the appropriate place.
- Remove the air filter together with the intake hose.
- Remove the coolant reservoir cap.
- Removing the filler neck of the washer fluid reservoir.
- Remove the cover of the fuse and relay box.
- Pull out the control unit and lay it aside.
- Detach the wheel well trim on the right and left.
- Remove the bumper.
- Remove the right-hand underride protection.
- Remove the 3-piece underbody cover.
- Remove the rear bench seat.
- Open the right-hand tank-fitting service lid.
- Remove the A/C control panel in accordance with the manufacturer's instructions.
- Remove the lower instrument panel trim on the driver's side.
Remove page 26 "Operating Instructions for End Customer" and add to the vehicle operating instruc-
tions.
Ident. No.: 1313525D_EN
1
Status: 25.09.2012

Heater Installation Location

1 Heater
1
Audi A4 / A5
© Webasto Thermo & Comfort SE
Installa-
tion loca-
tion
5