Table of Contents
Advertisement
Mercedes-Benz E-Class BR 211 / CLS BR 219
Fuel Connection
Remove the vehicle's fuel tank cap, ventilate the fuel tank and reinstall fuel tank cap.
CAUTION!
Catch any fuel running off with an appropriate container.
Install the fuel line so that they are protected from impact by rocks!
Unless specified otherwise, always fasten using cable ties.
Fit the fuel line and wiring harness with edge protectors around sharp edges.
Attention:
The wiring harness to the fuel pump should be installed based on the wiring harness installation
diagram.
1
2
3
2
1
2
1
Installing the fuel line
Remove the round protective rubber sleeve in
the side of the frame side rail and the long
protective rubber sleeve on the underside of
the frame side rail and punch a Ø 5mm hole.
Pull the round sleeve over the fuel line and
insert the fuel line into the frame side rail
through the round opening.
Slide on two rubber sliders on the fuel line
to protect from wear.
1 Round protective rubber sleeve
2 Fuel line
42
3 Rubber sliders [2x]
Route the fuel line out of the long opening
in the frame side rail.
Slide of grommet and insert in opening.
1 Fuel line
2 Long grommet
43
Replace the four single line clips with
double line clips.
Clip in the brake line and fuel line.
Route the fuel line back to the installation
location for the fuel pump.
1 Double line clips [4x]
2 Fuel line
44
Insert the
fuel line
in the
frame
side rail
Routing
the
fuel line
Fastening
the
fuel line
18
Hide quick links:
Advertisement
Table of Contents
