Wiring Harness Routing; Distribution Of Wiring Harnesses; Y-Adapter Connection; Installing The Wiring Harness - Webasto Mercedes-Benz E-Class BR 211 Installation Instructions Manual

Mercedes-Benz E-Class BR 211 / CLS BR 219
1
C
1
1
3
12
2
1
13
2
2
3
14
2
15

Installing the wiring harness

Unclip the harness conduit cover on the
right suspension strut mount, remove the
harness grommet from the guide. Cut the
side of the grommet and insert the Webasto
wiring harness. Seal the grommet with
adhesive sealant and reinstall in guide.
1 Webasto wiring harness
2 Cut open grommet
The figure shows coolant hose C covered
with braided hose protection.
Route the wiring harness under the
hoses to the rear bulkhead.
Cut open the rubber sleeve.
Route wiring harness to passenger
compartment.
Seal the protective rubber sleeve with
sealant.
1 Protective rubber sleeve
2 Wiring harness
Make electrical connection
Place wiring harness in passenger
compartment: Insert CAN plug in the plug
connector. Secure the ground cable to
existing ground point, route the fuse holder
behind the dash board to the fuse box, route
the fuel pump connector to the cable conduit
in the rocker panel, leave the wiring harness
for the T90 remote receiver in the foot area,
separate the six-pin plug from the wiring
harness.
1 Footrest plate
2 CAN plug connector
3 Grounding point
Connect the red and brown wires from the Y
adapter to the wires of the same color in the
remote wiring harness.
Connect the yellow wire from the Y adapter to
the gray-blue wire in the remote wiring
harness.
Crimp and shrink the connectors.
1 Connector for SPAL receiver wiring
harness
2 T90 remote connector (Y adapter)
3 Crimp shrink connectors [3x]
Wiring
harness
routing
Wiring
harness
routing
Distribut-
ion of
wiring
harnesses
Y- adapter
connection
9