Preliminary Work; Heater Installation Location - Webasto Thermo Top E Installation Documentation

Preliminary Work

WARNING!
- Open the fuel tank cap, ventilate the tank.
- Close the fuel tank cap again.
- Disconnect the battery "earth" or "ground" connection.
- Depressurise the cooling system!
- Copy the factory number from the original type label to the duplicate type label.
- Remove years that do not apply from the duplicate label.
- Attach the duplicate label (type label) in the appropriate place.
- Remove the engine cover.
- Remove the charge-air hose.
- Remove the air filter together with the intake hose
- Completely remove the battery together with the carrier.
- Remove the cover of the fuse and relay box in the engine compartment.
- Remove the front left wheel.
- Remove the left-hand wheel well trim.
- Remove the underride protection
- Remove the right-hand underbody trim.
- Remove the rear bench seat
- Open the right-hand tank-fitting service lid
- Remove the left-hand instrument panel trim.
- Remove the lower instrument panel trim on the front passenger side (only with Climatronic).
- Remove the lower instrument panel trim from the centre console (only with Climatronic).
- Provide Skoda additional bracket with corrosion protection according to VAG repair manual
Remove page 32 "Operating Instructions for End Customer" and add to the vehicle operating instruc-
tions.
1314084D_EN
1
1
Skoda Superb

Heater installation location

1 Heater
Installa-
tion loca-
tion
5